2012年10月12日星期五

High Capacity Heated Desiccant Dryer


Categories: High Capacity Dryers
Brand:KL
Comments:  Large heated desiccant dryer.


Introduction
Heat of compression air dryer is the use of compressed air drying absorber air compressor gas energy conversion when the heat generated by direct heating or hot compressed air to regeneration of the desiccant air drying equipment; no regeneration heater, gas consumption is regenerationless, the greatest degree of conservation of energy.
This equipment adopts PLC automatic control, simple, safe and reliable, renewable gas consumption is small, stable dew point, dew point requirements may be set according to the duty cycle and so on.

Work
High-temperature air from a centrifugal compressor into the first state in the regeneration of adsorber, the adsorbent of the adsorber temperature desorption from the adsorber into the back of the cooler after it is cooled down to room temperature water, after cooling, a large number of compressed airhydrogel formed in the gaseous liquid discharged through the drainage and then into the vapor-liquid separator to further separate the compressed liquid water, greatly reducing the workload adsorber adsorption.And then into the adsorber in the adsorption state of drying, to obtain the dew point of about -40 ℃ dry air.Adsorbent adsorber regeneration state when heated to a certain time, the adsorbent has reached a certain temperature, stop heating, the blowing cold at the same time to switch the system piping, heat the compressed air directly into the back of the cooler is cooled down to room temperature water, the state entered in the regeneration of the cold blow drying adsorber, after blowing cold air after the adsorption state of re-entering the absorber is to dry, and then out of the system.


KeyWords:


没有评论:

发表评论